Drawer organizers / KW-GRD-DIVKIT
Drawer Divider Kit
Dividers sized to your drawer's inside measurements, in the bay layout you choose.
About this piece
Enter the inside width, depth and the height you want, pick how many bays across and down, and the kit is cut to your drawer. Long dividers run front to back, short ones side to side, and they cross in half lap slots that press together by hand. Dividers are 2.4 mm thick with a rounded top edge, and every bottom edge carries anti slip feet.
The kit is cut two millimeters under your measurements so it drops in and stays put without pressing on the drawer sides.
What it fits
- Kitchen drawers: utensils, gadgets, spices on their side.
- Workshop drawers: tools, hardware boxes, tape.
- Bathroom vanities: brushes, bottles, small items.
- Desk drawers: stationery, cables, chargers.
- Dresser drawers: socks, belts, folded small items, with the tall height.
Up to six bays across and three down, which covers a 900 mm wide drawer with bays about 150 mm wide.
How to measure
- Inside width. Inside face to inside face, side to side, at the bottom of the drawer.
- Inside depth. Inside face to inside face, front to back, at the bottom.
- Divider height. Measure from the drawer floor to the lowest point of the rim or the underside of the drawer above, and take ten millimeters off so the drawer closes.
- Bays. Across is how many columns, down is how many rows. Three across and two down gives six bays.
Millimeters or inches. Enter the smaller measurement if the drawer is out of square.
Specifications
| Material | PLA |
|---|---|
| Dividers | 2.4 mm with slotted cross joints and anti slip feet |
| Fit | Cut 2 mm under your inside measurements |
| Size | 400 x 300 x 60 mm as shown, varies with your choices |
| Ships | Within 6 business days, Standard shipping (USPS Ground Advantage, 2 to 5 days after it ships) |
In the box
- All long and short dividers cut to your drawer, in the color you chose
- Anti slip feet fitted on every divider
- A slip with the layout and your measurements
Not included
- A floor. The dividers stand on the drawer floor; add the drawer baseplate if you want a grid floor under them.
Questions about the drawer divider kit
Can the bays be different widths?
The configurator divides evenly. For a layout like one wide bay and three narrow ones, email us the widths and we will quote it. The joint system handles any spacing.
How tall can the dividers be?
Up to 120 mm. Above about 80 mm we add a stiffening rib along the bottom, which is why the price steps up there.
Will it fit a drawer deeper than 300 mm?
Yes. Long dividers over 300 mm print as two pieces with a keyed splice that locks under the crossing slot, so it never shows.
Can I take it out and reconfigure it?
The slots are a hand fit, so the kit comes apart and goes back together. The bay count is fixed by the slot positions.
What if the drawer has rounded inside corners?
The outer dividers sit about a millimeter in from the sides, which clears most rounded corners. For a large radius, enter the inside measurement at the floor where the radius ends.
